There are many inks available for use with various marking devices. Industrial Inks for marking on non-porous surfaces are alcohol based usually and flammable so they MUST BE SHIPPED UPS GROUND. These inks vary from those that will dry in 3 seconds to much slower dry times. We are not responsible for damage caused by the chemicals in these inks. Industrial inks are for use with natural rubber stamps and may cause damage to photopolymer (clear) stamps.

Faster Drying means Faster drying pads as a rule. The MARK II ink pad is a reversible pad for use with the very fast drying inks. It is part of the MARK II system designed specifically for the #1250 industrial ink with a dry time of about 15 seconds.

We have the MSDS Available on request for the various inks we sell. Please feel free to contact us by email for the MSDS you may need when you purchase. These are available as pdf documents and we will be happy to forward them to you.  

For information about inks and your specific needs feel free to call us at 1-888-606-4579. We will do our best to insure you get the ink we think is best suited for your particular job.

Epoxy Based Inks: We have both a one part and the two part epoxy inks. The one part does not meet the MIL Spec for epoxy ink usually. The two part Epoxy require mixing and is usually  rolled out on a piece of glass with a brayer which we have on the epoxy ink pages. The two part is the only one we carry that meets MIL SPEC A-A-56032. The Mark II is the same ink and reactivator as the #1250 ink and reactivator.